By Tom Lehmann
Director, Bakery Assistance American Institute of Baking
Manhattan, Kansas
QUESTION: I
refrigerate my dough and use it over a three-day period. After two
days, I do not get the good browning of the crust that I got on the
first day. I've tried increasing the sugar, but then the crust gets
too dark on the first day if I don't adjust the baking time. What can
I do to get a more consistent crust color over the life of my dough?
ANSWER: To
answer your question we need to understand what is happening to your
dough during the refrigerated storage period. During refrigeration
(35-45 °F.) the yeast continues to ferment, but at a very slow
rate. During fermentation, the yeast metabolizes (feeds upon) sugars
and produces carbon dioxide, alcohol and acids as byproducts. This
creates sort of a "double whammy" against crust color
development. First, because the yeast has metabolized some of the
sugar, there is less sugar remaining to caramelize and develop crust
color. Second, the acids formed as yeast byproducts have an
inhibiting effect upon the rate of caramelization; hence, less color
development is achieved.
To correct this
problem, the most practical solution is to eliminate the sugar
entirely from the formula, or to reduce it to a minimum level, just
enough to sustain yeast activity (1 -1.5 percent based on flour) and
replace it with a non-fermenting sugar which can also caramelize to
develop crust color. The best sugar to use for this application is
lactose (milk sugar). The most economical source of lactose is sweet
dairy whey, which contains over 70 percent lactose. Non-fat dry milk
would also work well in this application as it contains approximately
50 percent lactose, plus the higher calcium content of the non-fat
dry milk would tend to have a better buffering affect upon the acids
formed during fermentation, which will also contribute to better
crust color development.
The amount of whey
to add to the formula will vary somewhat with dough formulation, and
baking conditions, but it has been my experience that 3 to 5 percent
whey (based on flour weight) gives the most satisfactory results.
QUESTION:
Many people use conditioners in their dough. My grandparents
never used a conditioner and neither have I. Why should I consider
using a conditioner for my dough? What is the advantage?
ANSWER:
Until well into the 1960's one of the more common methods of dough
production was to mix a dough and allow it to ferment for several
hours, usually in the mixing bowl. To use the dough, a piece was cut
or torn from the dough and shaped either by hand or dough roller
(sheeter). This dough would be used over the next several hours, and
because basic deck ovens were the order of the day, it was simply a
matter of increasing the bake temperature slightly or baking a little
longer if the crust didn't color up just right. Also, when it came to
mixing the dough, we may have only mixed a couple of doughs on a busy
Friday or Saturday night, which was no big deal even if we had to mix
during one of the busy periods.
Today, our mixing
and dough handling practices have changed. We're still using high
protein "pizza" flour, but we're now mixing our dough at
lower temperatures, in many cases 75 to 85 °F. as opposed to the
90 to 95 °F. temperatures used in the past. This can make the
dough more difficult to mix out (develop) properly. And because our
stores are busier than ever, we no longer have the luxury of being
able to prepare fresh dough during the course of the day. Instead, we
prepare our dough during"down" time, usually at the end of
a day, divide the dough into pieces (saves us the time of having to
do it later) and refrigerate the dough for use on the following
day(s). With this process, the dough receives a very controlled
amount of fermentation, verses the several hours of fermentation
common in the 60's. The control of fermentation, combined with
the high protein flour has led many operators to experience problems
with excessive dough shrinkage or "memory" as it is
sometimes called.
This is where "dough
conditioners" enter the picture. The most common dough
conditioner that we see in the pizza industry is the "reducing agent".
These are materials, which when added to the dough, cause it to
develop (mix) faster, and to become softer and more extensible, with
significantly less shrinkage characteristics. These dough
characteristics tend to lend themselves very well to today's
convenient and high-speed production styles.
In other cases,
many pizzerias are entering the arena of frozen and refrigerated or
deli pizzas. The doughs for these pizzas can often present challenges
that can be addressed through the use of dough conditioners. In this
case the main problem is that of dough weakening or collapse brought
about by a less than ideal freezing process or short time exposure of
the dough to higher than desired temperatures, such as might be
encountered with a deli or take-and-bake pizza while the customer is
transporting it to their home. Add to that the fact that the consumer
might then refrigerate or freeze the pizza, to be baked later, and
one can see why loss of dough strength can be an issue with this type
of pizza.
he dough
conditioners, which are effective in this application are referred to
as "oxidizers", and generally include products such as
potassium bromate, azodicarbonamide (ADA), and ascorbic acid (AA).
These products are
all very functional at very low use levels, measured in parts per
million (PPM), based on the flour weight.
Dough conditioners
are a functional part of the modern pizza dough recipe. Whether you
use them or not, or even need them is a question that unique to each
pizzeria. Times have changed, procedures have changed, and what we
expect from the dough has changed as our industry has changed (grown)
over the last 25 years and dough conditioners are one of the tools
available which can help us face this change. PMQ
<< Back to Table of Contents